Bonsai Pot Oval 003 3D Принт Модель

Printable Oval bonsai pot design for bonsai lovers.
the legs are printed separately to reduce support material.
More designs will come in the future.
You can print with default settings in your slicer. Pot and legs are designed separately to reduce support material waste. You can print the water tray and drain mesh only if needed.
I recommend 0.4mm nozzle for better quality. I have set support overhang angle to 60 degrees to reduce support materials. however you need to enable supports to print the leg cavities in the main body. for other parts you do not need supports. You will have to glue the legs to fix them to the pot after print. If your bed is not perfectly leveled you may need to remove some materials from the edges of the legs and leg cavities to fix the legs. you can use PLA or PETG depending on the environment where you going to put your bonsai pot (recommend PETG if the bonsai pot gets direct sunlight) .
Dimensions
- length : 219mm
- width : 135mm
- height : 30mm (with legs attached)